le_g09_wafer [Inspectron docs]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== LaserVision.HalconExport.G09E_Wafer ======

====== Release notes ======
===== Version 1.1.14.4683 =====
  * added additional stages to ridge detection to avoid misdetection on sides
===== Version 1.1.13.4630 =====
  * changed ridge detection. Ridge must be narrower
===== Version 1.1.12.4345 =====
  * ridge detection calibration
  * new unpump area detection
===== Version 1.1.11.4336 =====
  * new ridge detection based on begining and end of the ridge
===== Version 1.1.10.4304 =====
  * ridge location. changed filter conditions
  * bottom unpump now picks closest to area center
===== Version 1.1.9.4280 =====
  * small defects above unpump are ignored now
===== Version 1.1.8.4276 =====
  * added detection of top unpump area
  * better duplicate removal from bottom unpump
===== Version 1.1.7.4088 =====
  * Disabled defect detection on joints
===== Version 1.1.6.3937 =====
  * Applying ignore area before defect size analysis
===== Version 1.1.5.3797 =====
  * Decreased of cross matching threshold from 65% to 40%
===== Version 1.1.4.3791 =====
  * Decreased of cross matching threshold from 75% to 65%
===== Version 1.1.3.3766 =====
  * bottom unpump area high sensitivity

===== Version 1.1.2.3764 =====
  * bottom unpump area low contrast support

===== Version 1.1.1.3678 =====
  * LEV2 corrections

===== Version 1.1.0.3674 =====
  * Scaling support added

===== Version 1.0.10.3470 =====
  * decreased required accuracy for NCC in preparation

===== Version 1.0.9.3365 =====
  * Changed preparation to Corelation-based patter matching
===== Version 1.0.8.3364 =====
  * Increased ridge size to 130 px
  * added height condition for ridge for B-analysis
===== Version 1.0.7.3356 =====
  * New preparaion based on black edges.

===== Version 1.0.6.3339 =====
  * Increased minimum preparation component size to area of 2500
===== Version 1.0.5.3336 =====
  * Changed preparation to filter d-area better

===== Version 1.0.4.3322 =====
  * Fixed preparation rotation problem

===== Version 1.0.3.3321 =====
  * Marker detection added

===== Version 1.0.2.3316=====
  * Top unpump ignore area is tied to bottom unpump area on fixed distance of 17750 px (+-20px window)

===== Version 1.0.1.3315 =====
  * Copyed parameters from G09
  * Added Unpump area search