Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
linak:commands2 [2023/03/09 06:57] superuser |
linak:commands2 [2023/03/09 08:15] (current) superuser |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| ''stop <motor id>'' - Stop the motor with the specified ID | ''stop <motor id>'' - Stop the motor with the specified ID | ||
| - | ''init <motor id>'' - Set the height of the motor with the specified ID to zero | + | ''zero <motor id>'' - Set the height of the motor with the specified ID to zero |
| ''calibrate <motor id>'' - Calibrate the motor with the specified ID | ''calibrate <motor id>'' - Calibrate the motor with the specified ID | ||