Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
le_g09_wafer [2020/10/12 08:49] superuser |
le_g09_wafer [2022/10/28 06:01] (current) superuser |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== Release notes ====== | ====== Release notes ====== | ||
| + | ===== Version 1.1.14.4683 ===== | ||
| + | * added additional stages to ridge detection to avoid misdetection on sides | ||
| + | ===== Version 1.1.13.4630 ===== | ||
| + | * changed ridge detection. Ridge must be narrower | ||
| + | ===== Version 1.1.12.4345 ===== | ||
| + | * ridge detection calibration | ||
| + | * new unpump area detection | ||
| + | ===== Version 1.1.11.4336 ===== | ||
| + | * new ridge detection based on begining and end of the ridge | ||
| + | ===== Version 1.1.10.4304 ===== | ||
| + | * ridge location. changed filter conditions | ||
| + | * bottom unpump now picks closest to area center | ||
| + | ===== Version 1.1.9.4280 ===== | ||
| + | * small defects above unpump are ignored now | ||
| + | ===== Version 1.1.8.4276 ===== | ||
| + | * added detection of top unpump area | ||
| + | * better duplicate removal from bottom unpump | ||
| + | ===== Version 1.1.7.4088 ===== | ||
| + | * Disabled defect detection on joints | ||
| ===== Version 1.1.6.3937 ===== | ===== Version 1.1.6.3937 ===== | ||
| * Applying ignore area before defect size analysis | * Applying ignore area before defect size analysis | ||